Other
Other
1959 Other
100' (30.48 m) BOAT HOUSE-
- Seattle, Washington, United States
- Other
- Power
- Used
- Other
- Steel Hull
- VID# 2799119
Rare Opportunity Prime Location Fresh Water kept Custom Built Boathouse & Drydock facility for vessel upto 100ft LOA x 21ft Beam. Refit in 2005. Boathouse permit included.
$ 499,800 USD
1306 Main Street
FL 34236
Sarasota, FL USA
1-941-365-9095
info@sysyachtsales.com
1306 Main Street
FL 34236
Sarasota, FL USA
1-941-365-9095
info@sysyachtsales.com
Overview
Rare Opportunity
Prime Location Fresh Water kept Custom Built Boathouse & Drydock facility for vessel upto 100ft LOA x 21ft Beam. Refit in 2005. Boathouse permit included.
Key features include:
- Steel hull contruction
- Upgraded Bigtop Super Duty 22 ounce NFPA flame retardant PVC Vinyl top (2005)
- Klockner Moeller & Siemens circuit breakers features 100 amp & 50amp service for vessels plus additional breakers
- Westinghouse DT-3 Tansformer (3 Phase / 60Hz / 112.5kva)
- Ballast tanks with four controller pumps & Hytork 280 actuator valves to make raising and lowering drydock convenient
- 10 x Jim-Buoy Roller Bumpers for easy docking plus addtional 2 x Jim-Buoy 214 Giant Roller Fenders 14" Diameter x 44" Length at the boathouse entrance
SYS Yacht Sales is pleased to assist you in the purchase of this vessel. This boat is centrally listed by Denison Yachting. It is offered as a convenience by this broker/dealer to its clients and is not intended to convey direct representation of a particular vessel
Gallery
Quick Specs
Category: Other
Vessel ID: 2799119
LOA Feet100'
LOA Meters30.48''
Beam Feet42'
Draft Max Feet12'
TypePower
ConditionUsed
LOA: 100' (30.48 Meters)
Type: Power- Used
YearYear: 1959
Beam: 42'
Draft Max: 12'
Fuel Type: Other
Hull Material: Steel
Stabilizers: None
Displacement: 150
HIN/IMO: xxxx
Full Details
Overview
Drydock structure is a 100’x42’ barge hull design, with (2) 3’x20’x82’ wing walls. The hull has one longitudinal bulkhead on centerline and three transverse bulkheads, for a total of 8 compartments. In 2005 it was modified and refit which included:
- Two longitudinal steel pontoon tanks (5’4” diameter) were welded to the existing structure
- To these were added fiberglass decking panels to create an internal walkway around the structure
- A 29’ high galvanized steel 2” arch truss structure was installed on the wing wall tops to carry a Bigtop Super Duty 22 ounce NFPA flame retardant PVC Vinyl top
- The trusses are set at approximately 10’ centers. There is an entrance door at the shoreward end
- The outside end is open for vessel entrance, with netting and drawstring to close
The vessel that was stored in there was 98ft long x 20ft beam.
